LOXONE TOUCH TREE SERIAL NUMBER
LOXONE TOUCH TREE INSTALL

The Touch Surface is best attached to the surface in question by screwing it to the underside. The Touch Surface does not click when activated via the T6 key and no command is sent to the Miniserver when the touch is activated by T6. After activating, the Touch Surface will, every time you press the button (T1 – T6), send packets to the Miniserver. In this mode, all 6 touch points are always active and can be used at any time. On touch, a key-click is registered and forwarded to the Miniserver. Multi clicks are not supported.The activation process is to protect against any unintentional button presses such as leaning on a button when preparing food or spilling liquids onto the surface. This is done simply by pressing button 6 once, after 500ms (if no other button is touched during this time) the touch activates for 5 seconds (default time). During this time all keys (also key 6) can be used independently. Whenever a key is pressed during this time, the activation time is reset to 5 seconds. If no button is pressed for 5 seconds, the touch is deactivated again and must be reactivated via button 6 to continue use. The activation and its expiration time are visualised by means of the 5 LEDs counting down. This mode should be used when the Touch Surface is placed under tables, surfaces or kitchen tops. In this mode, the Touch Surface must be activated before it can be used.There are two modes of using the Touch Surface Air and by default, the surface is in the first of these listed below. These modes can be changed via Loxone Config in the touch surface periphery under the property “Activation necessary”. The device must not be used as part of safety-critical systems.The surface being used must be non-conductive in order for the Touch Surface to function. The installation must be carried out by a qualified technician in accordance with all applicable regulations.Įnsure that the device is protected from water.

LOXONE TOUCH TREE SERIAL NUMBER

Specifies the serial number of the device.įor Extensions: 'Auto' may only be used if only one Extension of this type is being used. When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. Provides the measured value of the current air humidityĭigital output to control the orientation light Provides the measured value of the current temperature Mount the device by snapping it onto the mounting frame.Ĭombined input for the 5 touch points according to the Loxone Switch Standard. Shortly after power-up, the status LED will blink orange if the wiring is correct (connection to Tree Extension and Miniserver is established).

LOXONE TOUCH TREE INSTALL

Install the mounting frame at the desired location.Ĭonnect the power supply (orange/white terminal) and Tree communication wires (green/white terminals). The Room Climate Sensor is better suited for a fast detection of changes in humidity.ĭatasheet Touch Pure Tree Table of Contents Please note that there is a certain delay when measuring humidity due to the housing. It also features a controllable orientation light and the integrated sensor measures temperature and relative humidity. The buttons can also be freely used for other applications. It is based on the Loxone switch standard. The large center touch zone is ideal for controlling the lighting, while the corner zones are suitable for controlling music and shading. When a button is touched, an audible click confirms the action. The Loxone Touch Pure Tree features five touch points on a glass surface to control the most important functions of a room.

Loxone touch tree